Each illuminated LED represents different functions, so it is
important to understand what each LED indicates.
Sometimes you will have two LEDs illuminated at the same
time. Below is the key to identifying each LED on the Valve Controller.
Alarm, Action, and Sensor all flashing in a sequence:
This represents the Valve controller is in pairing mode
and looking for a sensor to pair with. This is the
default mode of the valve controller and it will continue to
cycle until a Sensor is engaged and communicating. To get into this mode, you can hold the magnet on the valve controller for 15 seconds or longer and remove it.
Action LED flashing:
This represents the LevelSmart is currently in communicating with a Sensor and in the pairing process. This will happen immediately after you engage the Sensor. This pairing process lasts 2.5 minutes. The first 30 flashes are one second apart, and the next 2 minutes of flashes are four seconds apart. Once
successful pairing is completed, the Valve Controller will
show a solid green "Sensor" LED.
This represents that the LevelSmart Valve Controller and Sensor are successfully paired and in communication.
Sensor and Action LED:
This represents that the LevelSmart is successfully paired and currently filling, meaning the valve is open.
Sensor and Alarm LED:
This represents the sensor is paired successfully
and the magnet is on the valve controller. You will see this whenever you are using the magnet. If you do not see this, move the magnet around until you observe the red "Alarm" LED indicating it is engaged with the magnet. This is
used during a reset, or a valve check.